How to uninstall accessport without car

Created by Brandyn Mowat. Last updated: Aug 10, What is Recovery Mode? When Will This Happen? How to Avoid It: The simplest way to avoid putting your Accessport into recovery mode is prevention. This is because the install process can oftentimes be quite lenghty and if the vehicle runs low on power it could disable the Accessport from flashing the car.

Make sure and disable any alarm systems, immobilizers, or gauge systems which pull power or interact with the vehicles computer system. Aftermarket amplifiers and stereos in addition to capcitors can cause voltage fluctuation even when the vehicle is off so make sure they are unhooked from their power source.

Make sure the cable is seated properly both in the Accessport and OBD II port and do not wiggle around the cable ends during the install process. Make sure your unit is on the newest firmware by updating it using Accessport Manager.

You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Flashing to stock with Accessport without uninstalling? Thread starter Boje Start date Jul 9, Boje Go Kart Newbie. Can anyone tell me if it's possible to flash back to the stock tune with a Cobb Accessport without having to fully uninstall?

I know other platforms can do this with the AP, but can't find any info on whether we can do this on our cars. I know I can uninstall and re-flash but am hoping there's a quicker way. Acadia18 Autocross Champion. Yes, you can. You can download the Stage 0 map from Cobb's website. This should be it, but double check for your specific car configuration.