Toro greenkeeper 212 pdf

Quicklinks Diese Anleitung herunterladen. Table of Contents. EZ-Remote Kits. Transmitter and Receiver Components. Connecting the Transmitter Battery. Installation Procedures. Adjusting the Transmitter Station Number. Changing the Address Code. Electromagnetic Compatibility. Vorherige Seite. Seite 4: Connecting The Transmitter Battery 3. With the receiver lock up, install the receiver to the plug and slide the lock down to secure.

Plug the cable connector into the GreenKeeper receptacle as shown. Straighten the antenna wire so it extends vertically from the top of receiver.

Seite 6 Caution: Ensure the controller and receiver plug assembly are securely fastened to the wall before connecting the cable. Refer to Figure 2 on page 3 to install the receiver to the receiver plug. With the receiver lock in the up position, install the receiver onto the plug assembly. When the EZ-Remote is used to operate the controller, all automatic and manual controller opera- tions are suspended. If pause is not manually released, the station will remain paused for 10 minutes, then shut off.

Seite Changing The Address Code Changing the Address Code The transmitter and receiver are preset to the same address code enabling communication without addi- tional set up. FCC I. Teclado - Seis botones pulsadores para operar del control remoto. Enderece el cable de la antena de manera que se extienda verticalmente desde la parte superior del receptor.

Seite 18 3. Seite 23 Toro instalados por contratista. Page Resetting The Controller Memory Resetting the Controller Memory The GreenKeeper program memory can be reset to Figure 4 the permanent program values or cleared completely at any time without removing power. Resetting the permanent program erases all user input and replaces it with the permanent program values.

Clearing the program memory sets all program values to Off i. To set an Interval schedule see page PGM A Check the switch setting. The current watering schedule will be displayed. See page 14 for details. The current program start time or OFF will be displayed for start time number 1. Station number 1 will be flashing and its current run time or OFF will be shown. Page Controller Installation Controller Installation Note: The GreenKeeper indoor controller is not weather resistant and must be installed indoors or in a protected area.

For outdoor installation of an indoor model, a weather-resistant outdoor cabinet is available. Route the valve control wires between the valves and the controller. Note: Using 18 AWG 1. This cable is insulated for direct burial and is color-coded to sim- plify installation.

Remove the lower housing cover A by pulling outward on the handle. Route the valve wires or wire cable from the valves, into the controller cabinet. Note: Using 18 AWG 1mm multi-wire sprinkler valve connection cable is recommended. All electrical compo- 0. Do not connect the controller nents and installation procedures must comply directly to the pump starter. Page Controller Operation The Automatic mode is selected when the control dial is in the position. While in the automatic mode, the Controller Operation display will show two types of information: status and operation.

Page Turning Off The Greenkeeper Turning Off the GreenKeeper Flashing When the control dial is turned to the position, the controller immediately shuts off any watering operation currently in progress. Leaving the control dial in the position will prevent all automatic and manual watering operations. The controller will continue to track the current time and day of the week.

Page Using The Season Adjust Feature Using the Season Adjust Feature Changes in season and temperature generally require a change in station run time to maintain a healthy land- scape and conserve water. Turn the control dial to the position. Remove the lower front cover from the controller Replacing the Fuse housing by sliding it downward. The fuse protects the controller from damage due to power surges and excessive current draw through the Station Modules.

Page Troubleshooting If you are having a problem with the controller, check the following symptoms, possible causes and remedies. If the problem cannot be resolved or you would like assistance with any Toro irrigation product, call our toll-free Toro Help Line, Monday through Friday, — Page Warranty 2. Increase the separation between the equipment and receiver.